OVERVIEW
The Verus Engineering Full Brake Cooling Kit is configured in an OEM style format, with emphasis on the shortest route possible. Using a 3D printed carbon nylon inlet in place of the OEM radiator guides, a well-formed duct in the inner fender line, and a stainless backing plate with carbon ducting air to the center of the rotor, this is the brake cooling kit to have. The kit comes with everything necessary for an install, including pre-cut hoses. The OEM washer fluid reservoir *cannot be* retained!
During the design process; we utilized in-house scan data to design the components. This resulted in a product that features a near OEM fit and finish. This kit is specific to the GR86 front bumper.
The Verus brake cooling kit was designed for owners looking to maximize their brake's cooling efficiency and increase their brake's ability to do their job.
WHAT IS INCLUDED
- Backing Plate Incl. Carbon Ducts Riveted On (2, LH and RH)
- 2.5" Pre-Cut Silicone High Temp Brake Hose (2)
- 3.0" Pre-Cut Silicone High Temp Brake Hose (2)
- 3.0" Stainless Hose Clamp (4)
- 2.5" Stainless Hose Clamp (4)
- Fender Pancake Duct (2)
- 3D Printed Carbon Nylon Inlet Duct (2)
- Pancake Duct Bracket (2)
- Hardware Kit, Includes All Necessary Pieces to Install Kit Seamlessly
Features:
- Direct Air into the Center of the Rotor
- Stainless Backing Plate Adds Even More Airflow into Center of the Rotor
- OEM Type Install
- Installs in a Few Hours With Minimal Hand Tools and Know-How
- Short Routing to Maximum Cooling Efficiency
- Pulls Air from High-Pressure Zone in Front Bumper
Features:
- Direct Air into the Center of the Rotor
- Stainless Backing Plate Adds Even More Airflow into Center of the Rotor
- OEM Type Install
- Installs in a Few Hours With Minimal Hand Tools and Know-How
- Short Routing to Maximum Cooling Efficiency
- Pulls Air from High-Pressure Zone in Front Bumper
Specifications:
- Stainless Backing Plate
- Dry Carbon Air Duct
- Hard Plastic Fender Ducts (Pancake Duct)
- 3D Printed Carbon Nylon Inlet Duct
- Pre-cut 3" and 2.5" Brake Duct Hose
- All Necessary Hardware Included
- Made in the U.S.A.
Still need washer fluid?
The installation of our Brake Cooling Kit requires the removal of the OEM washer fluid reservoir. As a remedy for this, we offer a smaller reservoir replacement that grants the ability to run our Brake Cooling Kit as well as washer fluid. Check it out here.